Skip to content
Monday – Friday: 7 a.m. – 5 p.m.Mechanical (HVAC) contractor · LA Lic. 000000VerifyGeneral liability insurance
1 more license
  • Mechanical (HVAC) contractor · LA Lic. 000000Verify
  • General liability insurance
(337) 555-0102

Mini-splits and dehumidification

Cold, but still clammy? Start with the moisture.

Most clammy houses aren't too warm. They're too humid. We measure the humidity room by room, then fit mini-splits that cool and dry the rooms that need it.

  • Humidity measured before we quote
  • Mini-splits sized room by room
  • Written scope before any work
Sunlit living room with tall arched windows, shutters and a wood floor

Cold but clammy

Signs it's moisture, not heat.

If two or more of these sound like your house, humidity is the first thing to check.

  • Cold air, sticky skin

    The thermostat says 72 and the room still feels damp, mostly in the evening.

  • Fog on the inside of the glass

    Windows bead or fog indoors while the system runs.

  • A musty smell at start-up

    A smell when the system kicks on can point to a damp coil, drain or duct.

  • Clammy sheets, slow-drying towels

    Bedding feels cool and damp, and a towel is still wet the next day.

  • Short cycles

    The air conditioner cools the room, shuts off, and the damp comes straight back.

  • A number that disagrees with you

    Set to 74, it feels like 80. Temperature and humidity are two separate readings.

Why it happens

A cold room can still be a wet one.

Air conditioning removes moisture only while the compressor runs.

A system that's too big cools the room fast and shuts off before it has pulled the water out of the air. The EPA's guide to mold says to keep indoor humidity below 60 percent, ideally between 30 and 50. We check your rooms against that before we suggest a thing.

What we measure

  • Relative humidity in the rooms that feel worst

  • Dew point against the temperature of the glass and the ducts

  • How long your system runs, and how often it stops

  • Where the moisture comes in: drain, ducts, attic, doors

Air quality monitor with a digital readout on a shelf beside a potted plant

The humidity visit

Measure first. Then choose equipment.

Four steps, in this order. You can stop after any of them.

  1. 01

    Step 1: Measure

    We log humidity and temperature in the rooms you name, and read how long your system runs.

  2. 02

    Step 2: Find the source

    We look at the condensate drain, the ducts, the attic hatch and the door seals for where the moisture gets in.

  3. 03

    Step 3: Size by room

    We work out the load room by room. A unit sized for the wrong load cools too fast to dry the air.

  4. 04

    Step 4: Write it up

    You get a written scope: which rooms, which units, what each does and what isn't included.

Mini-split or central air

A sized mini-split against an oversized system.

What changes when the unit matches the room, and what doesn't.

A sized mini-split against an oversized system.
Oversized central systemMini-split sized to the room
How it runsOversized central systemBlasts cold air, reaches the setpoint and shuts offMini-split sized to the roomRuns longer at low speed, so it keeps pulling moisture out
The airOversized central systemCold and damp between cyclesMini-split sized to the roomCooled and dried together, room by room
DuctsOversized central systemLeaky ducts can pull in attic airMini-split sized to the roomNo ducts to draw humid attic air into the house
ControlOversized central systemOne thermostat for the whole houseMini-split sized to the roomA setting for each room
LimitsOversized central systemA bigger unit won't fix itMini-split sized to the roomIn a very damp house you may still need a dehumidifier

What we do

Install, dry and keep it running.

  • Humidity check

    Readings, a hunt for the source and a written scope, before any equipment.

    The check
  • Ductless mini-splits

    Wall and ceiling units for the rooms a central system never dried.

    Mini-splits
  • Dehumidifiers

    Ducted and whole-home units, and dry-mode setup, for the rooms that stay wet.

    Dehumidifiers
  • Service and drains

    Coil and filter cleaning and condensate drains, where a damp house often starts.

    All services

Who comes to the door

Ten of us, four you'll talk to first.

Nadege owns the firm and writes every scope. Pierre's crew sets the units.

  • Nadege Laurent

    Owner

    Writes every scope and signs off on every unit size.

  • Pierre Boudreaux

    Installation lead

    Sets the units, runs the line sets and tests the drain before he leaves.

  • Thien Dao

    Service technician

    Takes the humidity readings and finds where the moisture comes from.

  • Aline Bouchard

    Scheduling and scopes

    Books the visit and sends the written scope.

Customers

What changed in the room.

“The back bedroom stayed sticky with the air on. They left a meter in there for two days before quoting. The unit they sized runs quietly and the room finally feels dry.”

Christel F.Homeowner, Youngsville

“Aline sent the scope in writing: two rooms, two units, and what wasn't included. Nothing changed on install day.”

Diamond R.Homeowner, Scott

“They told me a mini-split alone wouldn't dry the whole house, and added a dehumidifier on the hall return. I'd rather hear that before paying than after.”

Matteo S.Homeowner, Carencro

Sample reviews.

Service area

Lafayette and the parishes around it

Lafayette itself, and the towns around it. Mini-split installs and humidity visits across Acadiana; if your town isn't listed, send the address and we'll say whether we can get there.

Front porch with a white railing looking onto a tree-lined street

Lafayette Parish

  • Scott
  • Broussard
  • Carencro
  • Duson

St. Martin Parish

  • Breaux Bridge
  • Cecilia
  • St. Martinville

Iberia Parish

  • New Iberia

Acadia Parish

  • Rayne

Vermilion Parish

  • Abbeville
  • Maurice

We don't take jobs in Baton Rouge, Lake Charles or the Houma area.

Before you call

Questions about clammy houses

Will a mini-split fix a clammy house on its own?

Often it helps a lot in the rooms it serves, because a sized unit runs longer at low speed and removes moisture as it goes. If the whole house is damp we may add a dehumidifier. We tell you which after we measure.

What humidity should my home sit at?

The EPA says to keep it below 60 percent, ideally between 30 and 50. We compare the readings in your rooms with that.

Is dry mode the same as a dehumidifier?

No. Dry mode lowers humidity while the unit runs, with less cooling. A dehumidifier is built to take moisture out all day. Which you need depends on the room and the season.

Why does my AC run and the house stay damp?

A system that's too big, a dirty coil, weak airflow or leaky ducts can each do it. The visit finds which.

What does the visit cost?

We give you the visit fee when you book, before anyone comes out, and say whether it counts toward the work. How pricing works has the rest.

Humidity visit

Tell us what you're noticing

A few lines is enough. Aline calls back to set a time for the meter readings, and we send the visit fee in writing before anyone comes out.

Hours
Monday – FridayToday
7 a.m. – 5 p.m.
SaturdayToday
8 a.m. – 12 p.m.
SundayToday
Closed

We reply on the next working day.